Imagine the crew at the first pole of a new route. The anchoring clamp that dead-ends the cable gets all the attention, and it is only half the story. Every newton of line tension flows through the clamp’s bail into a bracket, and the bracket hands the whole load to the pole. That makes the…
Picture the corner pole on a rural feeder just after sunrise. The span pulls one way, the coming wind will push the other, and nothing between them can carry compression. Everything rides on the one forged head that ties the strand to the earth. RaxPower has built this hardware category from a hot-forging floor in…
When the wind picks up across an open span, every fitting on the line is either carrying tension or merely holding weight. At the pole where the span terminates, the anchor tension clamp takes the full pull of the conductor. Picking the wrong clamp family at that point risks slippage, sag, and an unplanned outage.…
Picture the last pole before the line leaves town. One small fitting at its side carries the pulling force of every meter of cable behind it. That fitting is the anchor clamp, and buyers who treat it as a commodity tend to meet it again during storm season. RaxPower has manufactured pole line hardware since…
Picture the last pole of a new overhead route. The cable comes in from the span, and the tension of the whole line now hangs on one small wedge assembly at the pole. An anchoring clamp, often called a wedge type tension clamp, grips the cable, holds that tension, and passes the load into the…
Picture the last pole on a new feeder route. The conductor arrives under full tension, and the crew has one job left: end the span cleanly at the structure. The cable’s strain has to stop right there, not travel into the pole top or across the hardware. An anchor tension clamp is the dead-end fitting…
Picture a low-voltage line crossing a crowded street in Marseille, Bogota, or Riyadh: three or four insulated cores twisted in a spiral around a central messenger, swinging between concrete poles. Every attachment point on that line depends on an ABC clamp, and every one of those ABC clamps was sized by an engineer months before…
An anchor clamp is the fitting that grips an overhead cable, ends the span, and transfers the cable’s full pulling force to the pole or wall behind it. Picture the last pole on a street, right before the cable drops to a house: the conductors stop there, tight and loaded, and something has to catch…
An alley arm carries its load from one side only. There is no twin arm on the far side of the pole to share the weight of conductors, ice, and wind. Every pound acting at the arm tip must return into the pole through one steel member. That member is the alley arm brace, and…
Picture the back-alley pole where a full crossarm will never fit: wires leave to one side only, and the whole cantilevered arm hangs on its hardware. Correct alley arm brace installation keeps that side-mounted arm from rotating, sagging, or walking out of line under conductor load. Fitted correctly the brace is a quiet part for…
WhatsApp us